Posted October 15, 2019 7:00 pm by Comments

By Luke C.

Ruger Mk. IV 3D Printed Bolt Racker

Welcome back to the Rimfire Report! This week we’re going to talk about a home-cooked modification for the Ruger Mk. IV. The Ruger Mark .22LR series of pistols have been a staple in the rimfire community since its introduction in 1949. Offering at first simple design, the series has gone through 9 iterations since then to […]

Read More …

The post The Rimfire Report: 3D Printed Ruger Mark IV 22/45 Bolt Racker appeared first on The Firearm Blog.

…Read the Rest

Source:: The Firearm Blog

Leave a Reply

Your email address will not be published. Required fields are marked *