Posted November 15, 2015 11:00 am by Comments

By Robert Farago

How to skin a deer (courtesy ammoland.com)

From Ammoland:

Hang Your Deer

You start out the same way you would normally skin a deer. There are different thoughts about if it’s better to hang the deer head up or head down, but we’ve found that when you’re using an air compressor it doesn’t make a difference. Pick whichever way you’d like or are used to and hang the deer at a level where you can easily reach the whole critter . . .

Cut A Hole

Once your deer is hanging securely, it’s time to make the first cut. Use a knife to cut a small hole in the skin that covers the deer’s thigh. This hole should be just big enough to fit the nozzle of the air compressor. Ideally you want to make it so that no air can get out once you have the nozzle in. If you find that you’ve made the hole too big you can put a piece of cloth or tape around the nozzle so it fits.

Insert Nozzle

Next, simply insert the nozzle from the air compressor into the hole you made in the deer’s thigh. If it doesn’t fit, either make the hole larger or use tape or cloth around the …Read the Rest

Source:: Truth About Guns

Leave a Reply

Your email address will not be published. Required fields are marked *