For 3-D Printed Firearms, Go with ABS over PLA
By Nathan S.
An answer to a question I haven’t thought to ask, Freedom Printing 3D tested two of the most common materials used for 3-D printing, ABS and PLA. Using a simple hammer, the ABS lower receiver was able to stand up significantly better to impact. Comparatively, the PLA shattered immediately. Now, ABS Is harder to print, […]
The post For 3-D Printed Firearms, Go with ABS over PLA appeared first on The Firearm Blog.
Source:: The Firearm Blog
Other News
- Why Small Businesses Hate Bidenomics
- Biden Admin Wants To Send American Tax Dollars To Train Army Of Transgender Activists In India
- Attorney Tells CNN Docs Lacking Trump’s Signature Pose Serious Problem For Alvin Bragg’s Case
- Biden Admin Weighs California’s Latest Green Gambit That Could Set Off Chain Reaction Of Economic Pain
- Robbin’ the Hood
- Elite Colleges Show The Impact Of Lifelong Indoctrination
- Biden’s EV Policy Will Slow Innovation
- The New Segregation Movement
- Know Your Cheapskate Etiquette
- Bad Recipe
Leave a Reply