Posted May 5, 2017 5:06 pm by Comments

By Mike Searson

Sharp's Bros Jack Lower Reciver with the Armaspec XPDW Stock

By Mike Searson
The Armaspec XPDW stock gives you the PDW look without the hassle.

Armaspec XPDW Stock
Mike Searson
Mike Searson

USA –

Sharp’s Bros Jack Lower Reciver with the Armaspec XPDW Stock

We installed our Armaspec XPDW on a Sharp’s Bros. Jack Lower which is built by Spike’s Tactical. The metallic Cerakote on the front half of the lower was masterfully done by Nevada Cerakote out of Minden, Nevada. www.nevadacerakote.com

Building this lower gave us a few challenges due to the front half and at first we were concerned with adding an unconventional stock, but it installed with no problems.

Armaspec XPDW Stock – The Bad

We did hit one snag on the build. Our end plate had dual sling loops and would not allow the stock to completely retract. We simply replaced it with a standard end plate with no extensions. The lack of additional sling points may be a negative factor to some, but the single point location on the XPDW was fine for our purposes.

This stock is only rated for use on 5.56/223 …Read the Rest

Source:: AmmoLand

Leave a Reply

Your email address will not be published. Required fields are marked *