Posted April 1, 2015 8:47 am by Comments

By Patriot Outdoor News

Please note local, state and federal laws may apply to 3D printed firearms depending on your location.

A 3D printed 10/22 (based on Ruger’s popular rifle) has been printed and fired with factory parts/accessories. The folks over at PrintedFirearm.com have documented the whole process for the world to see. In fact, this project was actually started back in 2013, but there is now renewed interest in the project.

From their site:

These early prints were done in 2013 but with all the recent hype about 3d printed Ruger 10/22 Rifles being printed we wanted to confirm that yes its …read more

Via:: Patriot Outdoor News

Leave a Reply

Your email address will not be published. Required fields are marked *